How an STM Works

The scanning tunneling microscope (STM) works by scanning a very sharp metal wire tip over a surface. By bringing the tip very close to the surface, and by applying an electrical voltage to the tip or sample, we can image the surface at an extremely small scale – down to resolving individual atoms.

STM Atomic03 3D

3D rendered STM image of atoms

The STM is based on several principles. One is the quantum mechanical effect of tunneling. It is this effect that allows us to “see” the surface. Another principle is the piezoelectric effect. It is this effect that allows us to precisely scan the tip with angstrom-level control. Lastly, a feedback loop is required, which monitors the tunneling current and coordinates the current and the positioning of the tip. This is shown schematically below where the tunneling is from tip to surface with the tip rastering with piezoelectric positioning, with the feedback loop maintaining a current setpoint to generate a 3D image of the electronic topography:

Labeled schematic of scanning tunneling microscopy (STM)

Schematic of scanning tunneling microscopy (STM)


Introduction to the quantum mechanical effect of electron tunneling

Piezoelectric Effect
Piezoelectric Effect

How the piezoelectric effect is used in scanning probe microscopy

Feedback Loop
Feedback Loop

How a feedback loop works for STM and AFM


Contact Us: 480-758-5400


Captcha Code

Click the image to see another captcha.